Counter Drive Gear Assemble

Tools Required

• DT 46464  (DW240-160) Transaxle Case Outer Tapered Roller Bearing Race Adapter. See Special Tools .
• DT 46465  (DW240-170) Adapter Handle. See Special Tools .

Fig 1: Oil Seal & Transaxle Housing
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Press-fit the outer tapered roller bearing race until it contacts the transaxle housing.
1. Install a new outer tapered roller bearing race into the transaxle housing.
Fig 2: Pressing In A New Outer Tapered Roller Bearing Race Using DT 46464 & DT 46465
Courtesy of GENERAL MOTORS CORP.
IMPORTANT: Press-fit the shim until it contacts the transaxle case.
IMPORTANT: Install a shim of the same thickness as the one removed.
2. Install the shim to the transaxle case.
3. Using the DT 46464  (2) and the DT 46465  (1), press in a new outer tapered roller bearing race into the transaxle case. See Special Tools .
Fig 3: Counter Driven Gear
Courtesy of GENERAL MOTORS CORP.
4. Using a press, install the counter driven gear.
Fig 4: Tapered Roller Bearing & Transaxle Case Side
Courtesy of GENERAL MOTORS CORP.
5. Using a press, install a new tapered roller bearing of the transaxle case side.
Fig 5: Tapered Roller Bearing & Transaxle Housing Side
Courtesy of GENERAL MOTORS CORP.
6. Using a press, install a new tapered roller bearing of the transaxle housing side.