LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Automatic Transaxle - AISIN 81-40LE - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Transmission Fluid Temperature Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Transmission Fluid Temperature Sensor
    GM1774675Courtesy of GENERAL MOTORS CORP.
  1. Coat a new O-ring with ATF, then install it on the harness connector.
  2. Install the TFT sensor and wiring harness into the transaxle case.
    3. NOTE: Refer to Fastener Notice .
  3. Install the wiring harness retaining bolt.

    Tighten:  Tighten the bolt to 5.5 Nm (48 lb-in).

    4. Fig 2: Solenoid Wiring Harness Assembly
    GM1774664Courtesy of GENERAL MOTORS CORP.
  4. Connect the wiring harness to the five solenoids.
    5. Fig 3: Transmission Pan Bolts
    GM1774660Courtesy of GENERAL MOTORS CORP.
  5. Install a new gasket on the oil pan, then install the oil pan to the transaxle with the 18 retaining bolts.

    Tighten:  Tighten the bolts to 7.5 Nm (65 lb-in).

  6. Fill the transaxle with transmission fluid. Refer to Transmission Fluid Draining .
scientia non olet · About LEMON Manuals