Draining Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Fluid Drain Plug & Transaxle

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Vehicle Lifting and Jacking Notice .

Raise and support the vehicle
Place a suitable fluid drainage container under the transaxle.
Remove the fluid drain plug. Allow the fluid to drain completely.
Clean the drain plug threads.

NOTE: Refer to Fastener Notice .

Install the fluid drain plug.
Tighten: Tighten the fluid drain plug to 17 N.m (13 Ib ft).