Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Radiator Threaded Connector & Fluid Cooler Hoses

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Vehicle Lifting and Jacking Notice .

Raise and support the vehicle.
Drain the transaxle fluid.
Remove the clip from the radiator threaded connector, then disconnect the fluid cooler hoses.

Fig 2: View Of Fluid Cooler Inlet Pipe, Bolt & Transaxle

Courtesy of GENERAL MOTORS CORP.

Remove the fluid cooler inlet pipe bolt from the transaxle.
Remove the inlet pipe fitting nut from the transaxle.
Remove the fluid cooler inlet pipe and hoses.