Installation Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Connect the negative battery cable.
- Install the TCM and retaining bolts.
Tighten: Tighten the TCM retaining bolts to 5 N.m (44 lb in).
- Connect the TCM electrical connector.
- Connect the negative battery cable.
- Refer to Control Module References for programming and setup information.
NOTE:
Refer to Fastener Notice
.