Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: PNP Switch Electrical Connector & Wiring Harness

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Battery Disconnect Caution .

Disconnect the negative battery cable.
Disconnect the park/neutral position (PNP) switch electrical connector from the wiring harness.

Fig 2: Shift Control Cable & PNP Switch Lever

Courtesy of GENERAL MOTORS CORP.

Remove the E-ring.
Disconnect the shift control cable from the PNP switch lever.

Fig 3: Retaining Nut, Washer & Control Lever

Courtesy of GENERAL MOTORS CORP.

Remove the retaining nut and then remove the washer and the control lever.
Using a driver, unstake the lock washer and remove the nut.