One Way Clutch Disassemble

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Turning Rear Planetary Sun Gear & One-Way Clutch

Courtesy of GENERAL MOTORS CORP.

Install the one-way clutch and thrust washer to the rear planetary sun gear.
Hold the rear planetary sun gear and turn the one-way clutch. The one-way clutch should turn freely clockwise and should lock counterclockwise.

Fig 2: Snap Ring, 2nd Brake Hub & Screwdriver

Courtesy of GENERAL MOTORS CORP.

Using a screwdriver, remove the snap ring from the 2nd brake hub.

Fig 3: One-Way Clutch & 2nd Brake Hub

Courtesy of GENERAL MOTORS CORP.

Remove the one-way clutch from the 2nd brake hub.

Fig 4: Retainer, 2nd Brake Hub & Screwdriver

Courtesy of GENERAL MOTORS CORP.

Using a small screwdriver, remove the retainer from the 2nd brake hub.