LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Automatic Transaxle - AISIN 81-40LE - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Repair Instructions - On Vehicle >> Floor Shift Control Cable Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Control Cable Adjusting Nut
    GM1245812Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Remove the floor console. Refer to Front Floor Console Replacement (Notchback) or Front Floor Console Replacement (Hatchback) .
  3. Remove the cable adjusting nut.
  4. Disconnect the shift control cable from the shift control lever assembly.
    5. Fig 2: Shift Control Cable & PNP Switch Lever
    GM1245820Courtesy of GENERAL MOTORS CORP.
  5. Remove the shift control cable retaining E-ring.
  6. Disconnect the shift control cable from the park/neutral position (PNP) switch.
    7. Fig 3: Shift Control Cable, Bracket & Fastener
    GM1245826Courtesy of GENERAL MOTORS CORP.
  7. Remove the E-ring from the shift control cable bracket and disconnect the shift control cable.
  8. Disconnect the shift control cable from the shift control cable fastener.
  9. Remove the shift control cable from the vehicle.
scientia non olet · About LEMON Manuals