Counter Drive Gear Assemble: Assemble

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Oil Seal & Transaxle Housing

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Press-fit the outer tapered roller bearing race until it contacts the transaxle housing.

Install a new outer tapered roller bearing race into the transaxle housing.

Fig 2: Pressing In A New Outer Tapered Roller Bearing Race Using DT 46464 & DT 46465

Courtesy of GENERAL MOTORS CORP.

IMPORTANT: Press-fit the shim until it contacts the transaxle case.

IMPORTANT: Install a shim of the same thickness as the one removed.

Install the shim to the transaxle case.
Using the DT 46464 (2) and the DT 46465 (1), press in a new outer tapered roller bearing race into the transaxle case. See Special Tools .

Fig 3: Counter Driven Gear

Courtesy of GENERAL MOTORS CORP.

Using a press, install the counter driven gear.

Fig 4: Tapered Roller Bearing & Transaxle Case Side

Courtesy of GENERAL MOTORS CORP.

Using a press, install a new tapered roller bearing of the transaxle case side.

Fig 5: Tapered Roller Bearing & Transaxle Housing Side

Courtesy of GENERAL MOTORS CORP.

Using a press, install a new tapered roller bearing of the transaxle housing side.