Cooler Pipe Bending and Choke Inspection
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Replace the pipe(s) as necessary.
- Apply compressed air of 2 kg/cm (28 psi) from cooler pipe inlet side (1), inspect whether there is not cooler pipe choke by confirming smooth air flow.
- Remove foreign particles and clean the inside of pipe line(s), as necessary.
IMPORTANT:
Inspect for abnormal pipe bending in the cooler pipe, pipe deformation or other damage.