LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 96 (Automatic Transaxle - AISIN 81-40LE - Removal & Installation, Service, Overhaul, Troubleshooting & Diagnosis) >> Diagnostic Information and Procedures >> Automatic Transmission Fluid Leaks >> Powder Method

Powder Method

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Thoroughly clean the suspected leak area.
  2. Apply an aerosol type powder, such as foot powder, to the suspected leak area.
  3. Allow the transaxle to reach the normal operating temperature of 176-194°F (80-90°C).
  4. Turn the engine OFF.
  5. Inspect the suspected leak area and trace the leak path through the powder to find the source of the leak.
  6. Make the necessary repairs to correct the leak. Once the leak point is found, the source of the leak must be determined and repaired.
scientia non olet · About LEMON Manuals