Theft Deterrent Alarm Inoperative
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
| Step | Action | Yes | No |
|---|---|---|---|
| Schematic Reference: Theft Deterrent System Schematics (Notchback) or Theft Deterrent System Schematics (Hatchback) Connector End View Reference: Theft Deterrent System Connector End Views (Notchback) or Theft Deterrent System Connector End Views (Hatchback) DEFINITION: The theft deterrent alarm does not chirp when the system is armed and does not sound when the system is in alarm mode. |
|||
| 1 | Did you perform the Diagnostic System Check - Vehicle? | Go to Step 2 | Go to Diagnostic System Check - Vehicle |
| 2 |
|
Go to Step 3 | Go to Content Theft Deterrent (CTD) Alarm Mode Inoperative |
| 3 |
|
Go to Step 4 | Go to Step 5 |
| 4 |
|
Go to Step 7 | Go to Step 6 |
| 5 |
|
Go to Step 11 | - |
| 6 | Test for an open in the ground feed circuit of the theft deterrent alarm. Refer to Testing for Continuity
and Wiring Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 8 |
| 7 | Test for a poor connection at the theft deterrent alarm. Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 9 |
| 8 | Test for a poor connection at the remote control door lock receiver (RCDLR). Refer to Testing for Intermittent Conditions and Poor Connections
and Connector Repairs
. Did you find and correct the condition? |
Go to Step 11 | Go to Step 10 |
| 9 | Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement (Hatchback)
or Remote Control Door Lock Receiver Replacement (Notchback)
. Did you complete the replacement? |
Go to Step 11 | - |
| 10 | Replace the theft deterrent alarm. Refer to Theft Deterrent Alarm Replacement . Did you complete the replacement? |
Go to Step 11 | - |
| 11 | Operate the system in order to verify the repair. Did you correct the condition? |
System OK | Go to Step 2 |