LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 93 (Theft Deterrent System) >> Diagnostic Information and Procedures >> Content Theft Deterrent (CTD) Alarm Mode Always On

Content Theft Deterrent (CTD) Alarm Mode Always On

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Yes No
Schematic Reference:  Theft Deterrent System Schematics (Notchback)   or  Theft Deterrent System Schematics (Hatchback)  
Connector End View Reference:  Theft Deterrent System Connector End Views (Notchback)   or  Theft Deterrent System Connector End Views (Hatchback)  
DEFINITION: The content theft deterrent (CTD) alarm is always ON.
1 Did you perform the Diagnostic System Check - Vehicle? Go to Step 2  Go to Diagnostic System Check - Vehicle
2 Disconnect the remote control door lock receiver (RCDLR).
Does the alarm turn off?
Go to Step 5  Go to Step 3 
3
  1. Disconnect the theft deterrent alarm.
  2. Test for a short to ground in the alarm ground. Refer to Testing for Short to Ground and Wiring Repairs .
Did you find and correct the condition?
Go to Step 8  Go to Step 4 
4 Test for a poor connection at the theft deterrent alarm. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
Go to Step 8  Go to Step 7 
5 Test for a poor connection at the RCDLR. Refer to Testing for Intermittent Conditions and Poor Connections and Connector Repairs .
Did you find and correct the condition?
Go to Step 8  Go to Step 6 
6 Replace the RCDLR. Refer to Remote Control Door Lock Receiver Replacement (Hatchback) or Remote Control Door Lock Receiver Replacement (Notchback) .
Did you complete the replacement?
Go to Step 8  -
7 Replace the theft deterrent alarm. Refer to Theft Deterrent Alarm Replacement .
Did you complete the replacement?
Go to Step 8  -
8 Operate the system in order to verify the repair.
Did you correct the condition?
System OK Go to Step 2