LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Manifold Absolute Pressure Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Manifold Absolute Pressure Sensor
    GM1348510Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the MAP sensor with the bolt.

    Tighten:  Tighten the MAP sensor bolt to 10 N.m (89 lb in).

  2. Connect the vacuum hose.
  3. Connect the MAP sensor electrical connector.
  4. Connect the negative battery cable.
scientia non olet · About LEMON Manuals