LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Intake Manifold Tuning Valve Actuator Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Fuel Rail
    GM1371864Courtesy of GENERAL MOTORS CORP.
  1. Install the IMT valve actuator valve to the IMT valve.
    2. NOTE: Refer to Fastener Notice .
  2. Install the IMT valve actuator valve bolts.

    Tighten:  Tighten the IMT valve actuator valve retaining bolts to 12 N.m (106 lb ft).

  3. Connect the vacuum hose to the IMT valve actuator valve.
scientia non olet · About LEMON Manuals