LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Fuel Tank Pressure Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel fill cap.
  2. CAUTION: Refer to Battery Disconnect Caution .
  3. Disconnect the negative battery cable.
  4. Remove the rear seat. Refer to Rear Seat Cushion Replacement .
  5. Fig 1: Removing/Installing Fuel Pump Access Cover
    GM1376163Courtesy of GENERAL MOTORS CORP.
  6. Remove the fuel sender assembly access cover.
  7. Fig 2: View of Fuel Tank Pressure Sensor Electrical Connector
    GM1376164Courtesy of GENERAL MOTORS CORP.
  8. Disconnect the fuel tank pressure (FTP) sensor electrical connector.
  9. Remove the FTP from the fuel sender assembly.