LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Evaporative Emission Canister Vent Solenoid Valve Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing EVAP Canister Vent Solenoid Valve
    GM1528398Courtesy of GENERAL MOTORS CORP.
  1. Connect the EVAP canister vent solenoid valve hoses.
  2. Install the EVAP canister vent solenoid valve hose clip.
  3. Connect the EVAP canister vent solenoid valve electrical connector.
    4. Fig 2: Removing/Installing EVAP Canister Vent Solenoid Valve Bracket
    GM1528395Courtesy of GENERAL MOTORS CORP.
  4. Install the EVAP canister vent solenoid valve bracket to the EVAP canister vent solenoid valve.
    5. Fig 3: View Of EVAP Canister Vent Solenoid Valve Bracket And Bolt
    GM1528391Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  5. Install the bolt to the EVAP canister vent solenoid valve bracket.

    Tighten:  Tighten the EVAP canister vent solenoid valve bracket bolt to 4 N.m (35 lb in).

  6. Lower the vehicle.
  7. Connect the negative battery cable, if disconnected.
scientia non olet · About LEMON Manuals