LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Engine Control Module Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Engine Control Module Nuts
    GM1915858Courtesy of GENERAL MOTORS CORP.
  1. Position the ECM in place.
    2. NOTE: Refer to Fastener Notice .
  2. Install the ECM to the ECM mount and install the retaining bolts.

    Tighten:  Tighten the ECM retaining bolts to 4 N.m (35 lb in).

    3. Fig 2: View Of Engine Control Module
    GM1915851Courtesy of GENERAL MOTORS CORP.
  3. Connect the ECM connectors.
  4. Connect the negative battery cable.
  5. Perform the following procedures:
  6. Refer to Control Module References for programming and setup information.
scientia non olet · About LEMON Manuals