LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Crankshaft Position Sensor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Removing/Installing CKP Sensor And Bolt
    GM1289479Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  1. Install the CKP sensor with the bolt.

    Tighten:  Tighten the CKP sensor bolt to 6.5 N.m (58 lb in).

    2. Fig 2: Disconnecting/Connecting Crankshaft Position Sensor
    GM1289478Courtesy of GENERAL MOTORS CORP.
  2. Connect the CKP sensor electrical connector.
  3. Connect the negative battery cable.
scientia non olet · About LEMON Manuals