LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 92 (Engine Controls And Fuel - 1.6L - Introduction (2 Of 2)) >> Repair Instructions >> Camshaft Position Sensor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Identifying Cover Screws
    GM1371851Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Battery Disconnect Caution .
  1. Disconnect the negative battery cable.
  2. Remove the engine cover bolts and the nuts.
  3. Remove the engine cover.
    4. Fig 2: Disconnecting/Connecting CMP Sensor Electrical Connector And Bolt
    GM1289481Courtesy of GENERAL MOTORS CORP.
  4. Disconnect the camshaft position (CMP) sensor electrical connector.
  5. Remove the timing belt front cover. Refer to Timing Belt Replacement .
scientia non olet · About LEMON Manuals