Inspection Procedure
WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the brake drum. Refer to Brake Drum Replacement .
- Measure the lining thickness.
Specification: The minimum lining thickness is 0.5 mm (0.02 in).
- If the lining thickness is less than the specification, or if a defect is found, replace the linings. Refer to Brake Shoe Replacement .
- Install the brake drum. Refer to Brake Drum Replacement .
CAUTION:
Refer to Brake Dust Caution
.
IMPORTANT:
Replace the shoe and lining assembly in axle sets only.