LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Disc Brake System) >> Repair Instructions >> Brake Rotor Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Rotor Detent Screw
    GM1245700Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Brake Caliper Notice .
    IMPORTANT: To guarantee uniform braking on both sides, both rotors must have identical surfaces regarding smoothness and scoring depth. For this reason, always replace both rotors.
  1. Remove the caliper assembly without disconnecting the brake hoses. Refer to Brake Caliper Replacement .
  2. Remove the caliper bracket.
  3. Remove the rotor-to-front wheel hub detent screw from the rotor and the front wheel hub.
  4. Pull off the rotor.
scientia non olet · About LEMON Manuals