LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 87 (Disc Brake System) >> Diagnostic Information and Procedures >> Brake Pad Inspection

Brake Pad Inspection

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle .
  2. Remove the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  3. Inspect the brake pads for wear.
  4. Measure the thickness.

    Specification:  The minimum thickness of the inner or the outer pad is 2 mm (0.08 in).

  5. Install the brake pads in axle sets only.
  6. Install the front tire and wheel assembly. Refer to Tire and Wheel Removal and Installation .
  7. Lower the vehicle
scientia non olet · About LEMON Manuals