Brake Fluid and Brake Fluid Handling

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Refer to Brake Fluid Irritant Caution .

CAUTION: Refer to Brake Fluid Caution .

NOTE: Refer to Filling the Master Cylinder Notice .

NOTE: Refer to Brake Fluid Damage to Electrical Connections Notice .

NOTE: Refer to Brake Fluid Effects on Paint and Electrical Components Notice .

NOTE: Refer to Clutch Hydraulic System Lubricant Notice .

NOTE: Refer to Using Proper Power Steering Fluid Notice .

Master cylinder fluid should meet the DOT 3 specification. Use DOT 4 for heavy duty applications, such as trailer towing or mountain driving.

Use only clear fluid from a sealed container. Fluid that is exposed to the air will absorb moisture. Water in the master cylinder fluid will cause the fluid to boil and the rubber components to deteriorate.

Thoroughly clean the master cylinder reservoir cap before removing it. Do not let any dirt or foreign material fall into the fluid reservoir.

There is a fluid level switch in the master cylinder reservoir. When the fluid level is low, the brake lamp in the instrument cluster will turn ON. The correct master cylinder fluid level is marked on the left side of the master cylinder reservoir. If the fluid level is below the MIN indicator mark, check the hydraulic brake system for leaks, and then refill the reservoir to the MAX indicator mark.