LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 73 (Seat Belt System) >> Diagnostic Information and Procedures >> Seat Belt Indicator Circuit Malfunction

Seat Belt Indicator Circuit Malfunction

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
Step Action Values Yes No
1 Inspect fuse F3.
Is fuse F3 open?		 - Go to Step 2  Go to Step 3 
2
  1. Inspect for a short circuit and repair, if necessary.
  2. Replace the fuse.
Is the repair complete?		 - System OK -
3
  1. Turn the ignition ON.
  2. Measure the voltage at fuse F3.
Does the voltage measure as specified?		 11-14 V Go to Step 5  Go to Step 4 
4 Repair the open power supply circuit for fuse F3.
Is the repair complete?		 - System OK -
5
  1. Disconnect the seat belt connector under the driver seat.
  2. Connect a jumper wire between the terminals of the seat belt harness connector.
  3. Turn the ignition ON.
Does the seat belt warning lamp turn ON?		 - Go to Step 6  Go to Step 7 
6 Replace the seat belt switch.
Is the repair complete?		 - System OK -
7
  1. Remove the instrument cluster.
  2. Inspect the seat belt warning lamp bulb.
Is the warning lamp OK?		 - Go to Step 9  Go to Step 8 
8 Replace the seat belt warning lamp bulb.
Is the repair complete?		 - System OK -
9 Repair the open circuit between terminal B7 of the instrument cluster and ground.
Is the repair complete?		 - System OK -
scientia non olet · About LEMON Manuals