LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 70 (HVAC System - Manual) >> Repair Instructions >> Blower Motor Switch Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Blower Motor Switch & Knob Mount Support
    GM1251930Courtesy of GENERAL MOTORS CORP.
  1. Install the spring and the electrical contact washer over the blower switch knob post.
  2. Align the contact key with the post keyway.
  3. Position the switch assembly over the mount posts.
  4. Install the switch assembly with the screws.
  5. Connect the electrical connectors to the rear of the control assembly.
  6. Install the HVAC control assembly. Refer to Heater and Air Conditioning Control Replacement (Hatchback)  or Heater and Air Conditioning Control Replacement (Notchback) .
  7. Connect the negative battery cable.
  8. Perform an operational check of the blower switch positions.
scientia non olet · About LEMON Manuals