Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Inserting Wire Loops Along Rear Seat Cushion Into Floor Pan

Courtesy of GENERAL MOTORS CORP.

Insert the wire loops along the front edge of the rear seat cushion into the recesses in the floor pan.

Fig 2: View of Bolt of Rear Seat Back

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear seat cushion with the bolt.
Tighten: Tighten the rear seat cushion bolt to 25 N.m (18 lb ft).