Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Bolts Securing Rear Seat Backs to Hinges

Courtesy of GENERAL MOTORS CORP.

Install the rear seatback by inserting the seat hinge posts into the lower rear quarter upper trim panel.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the seat backs to the hinges with the bolts.
Tighten: Tighten the seatback bolts to 25 N.m (18 lb ft).
Raise the rear seat backs in the upright position.