Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Lock Assembly and Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the rear seatback lock assembly with the screws.
Tighten: Tighten the rear seat back lock assembly screws to 20 N.m (15 lb ft).
Install the rear seatback cover to its original position.
Install the rear seatback lock release knob.