LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 66 (Steering Wheel & Steering Column) >> Repair Instructions >> Steering Wheel Replacement (Notchback) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Clip the contact ring on the steering wheel, if necessary.
  2. Align the match marks on the steering wheel and the steering column shaft. Turn the signal-canceling cam on the wheel to the left.
    3. Fig 1: Steering Wheel Components
    GM1716003Courtesy of GENERAL MOTORS CORP.
    NOTE: Refer to Fastener Notice .
  3. Install the retaining clip and the steering wheel nut (4).

    Tighten:  Tighten the steering wheel nut to 38 N.m (28 lb ft).

  4. Bend the tabs to secure the retaining clip.
  5. Install the SIR module. Refer to Inflatable Restraint Steering Wheel Module Replacement .
  6. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals