LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 64 (Lighting Systems) >> Repair Instructions >> Rear License Lamp Replacement (Typical) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of License Lamp Assembly
    GM1248426Courtesy of GENERAL MOTORS CORP.
  1. Install a new bulb.
  2. Connect the electrical connector.
    3. NOTE: Refer to Fastener Notice .
  3. Install the lamp assembly with the screws.

    Tighten:  Tighten the license plate lamp screws to 1.5 N.m (13 lb in).

scientia non olet · About LEMON Manuals