LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Interior Trim And Paneling) >> Repair Instructions >> Rear Door Trim Panel Replacement (Notchback) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Channel Molding
    GM1720604Courtesy of GENERAL MOTORS CORP.
  1. Lower the rear window.
  2. Remove the rear window regulator handle. Refer to Door Window Regulator Handle Replacement .
  3. Remove the door pull screw.
  4. Remove the inside door handle.
    5. Fig 2: Rear Door Interior Garnish Molding
    GM1721762Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear door interior garnish molding.
  6. Remove the screws at the base of the trim panel.
  7. Pry off the trim panel.
scientia non olet · About LEMON Manuals