LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 61 (Interior Trim And Paneling) >> Repair Instructions >> Front Side Door Trim Panel Replacement (Notchback) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Channel Molding
    GM1720604Courtesy of GENERAL MOTORS CORP.
  1. Lower the front window.
  2. Remove the window regulator handle, if equipped.
  3. Remove the door pull screws.
  4. Using a flat-bladed tool, gently pry off the inside door pull handle cover.
  5. Remove the inside door handle bezel.
    6. Fig 2: Front Side Door Trim Panel
    GM1721765Courtesy of GENERAL MOTORS CORP.
  6. Pry off the trim panel.
  7. Disconnect the necessary electrical connectors, if equipped.
scientia non olet · About LEMON Manuals