LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 59 (Battery, Charging System And Starting System) >> Repair Instructions >> Starter Motor Replacement (1.4L/1.5L SOHC and 1.4L/1.6L DOHC) >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Starter
    GM1241864Courtesy of GENERAL MOTORS CORP.
  1. Place the starter assembly in position.
    2. NOTE: Refer to Fastener Notice .
  2. Install the upper and the lower starter mounting bolts.

    Tighten:  Tighten the starter mounting bolts to 43 N.m (32 lb ft).

    3. Fig 2: View Of Starter Assembly
    GM1241866Courtesy of GENERAL MOTORS CORP.
  3. Position the starter electrical wire on the solenoid terminal.
  4. Install the starter solenoid nuts.

    Tighten:  Tighten the starter solenoid nuts to 15 N.m (11 lb ft).

  5. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection .
scientia non olet · About LEMON Manuals