LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Bumper System & Fascia) >> Repair Instructions >> Rear Bumper Fascia Replacement (Hatchback) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2008 Suzuki Swift +, 2008 Pontiac Wave, and 2008 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View of Screws Behind Fascia
    GM1248505Courtesy of GENERAL MOTORS CORP.
  1. Remove the screws and the mud guards.
  2. Remove the screws and the splash shields.
  3. Remove the screws behind the fascia.
    4. Fig 2: View of Nuts Behind Rear Bumper Energy Absorber
    GM1248506Courtesy of GENERAL MOTORS CORP.
  4. Remove the nuts behind the rear bumper energy absorber.
    5. Fig 3: View of Bolts In Luggage Compartment
    GM1248322Courtesy of GENERAL MOTORS CORP.
  5. Remove the rear cargo area trim panels.

    Refer to Cargo Area Side Trim Panel Replacement (Hatchback) .

  6. Remove the bolts in the luggage compartment.
    7. Fig 4: View of Fascia Screws Beneath Taillamps
    GM1248248Courtesy of GENERAL MOTORS CORP.
  7. Remove the bolts and the exterior trim panels beneath the tail lamps.
  8. Remove the fascia screws beneath the tail lamps.
    9. Fig 5: View of Rear Fascia
    GM1248249Courtesy of GENERAL MOTORS CORP.
  9. Remove the rear upper fascia screws.
  10. Remove the fascia.
scientia non olet · About LEMON Manuals