LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 53 (Manual Steering System) >> Repair Instructions >> Rack and Pinion Preload Bearing Adjustment >> Adjustment Procedure

Adjustment Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Refer to Fastener Notice in Cautions and Notices.
IMPORTANT: Make the rack bearing adjustment with the front wheel raised and the steering wheel centered. Be sure to check the returnability of the steering wheel to center after the adjustment.
    Fig 1: Rack And Pinion Preload Bearing Locknut
    GM1248349Courtesy of GENERAL MOTORS CORP.
  1. Loosen the locknut and turn the adjuster plug clockwise until a torque of 10 N.m (88 lb-in) is obtained.
  2. Back the adjuster plug off by 55-65 degrees. Check the pinion preloaded torque is within the range 0.9-1.7 N.m (8 to 15 lb in).
  3. Tighten the adjuster plug locknut while holding the adjuster plug stationary.

    Tighten:  Tighten the adjuster plug locknut to 70 N.m (52 lb ft).

scientia non olet · About LEMON Manuals