LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Front Suspension System) >> Repair Instructions >> Wheel Hub, Bearing, Knuckle, and Seal Replacement >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Outer Snap Ring, Wheel Bearing & Components
    GM1241987Courtesy of GENERAL MOTORS CORP.
  1. Install the outer snap ring and push the wheel bearing into place with the J 37105-1  , theJ 37105-2  , the.500-20  , and theJ 36661-2  . See Special Tools and Equipment .
    2. Fig 2: Inner Snap Ring, Push The Wheel Hub & Components
    GM1241988Courtesy of GENERAL MOTORS CORP.
  2. Install the disc brake splash. Refer to Disc Brake Splash Shield Replacement - Front in Disc Brakes.
  3. Install the inner snap ring and push the wheel hub into place with the J 37105-3  , theJ 37105-2  , the500-20  , and theJ 36661-2  . See Special Tools and Equipment .
  4. Install the drive axle into the front wheel hub. Refer to Strut Assembly Replacement .
scientia non olet · About LEMON Manuals