Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: U-Clamp Bolts & Stabilizer Bar

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the U-clamp bolts to the stabilizer bar.
Tighten: Tighten the U-clamp bolts to the stabilizer bar to 25 N.m (18 lb ft).
Remove the crossmember assembly.