LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Front Suspension System) >> Repair Instructions >> Stabilizer Shaft Link Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Stabilizer Shaft-To-Knuckle Nut & Shaft-To-Link Nut
    GM1241958Courtesy of GENERAL MOTORS CORP.
  1. Install the stabilizer shaft into the vehicle.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the stabilizer shaft-to-knuckle nut and the shaft-to-link nut.

    Tighten:  Tighten the stabilizer shaft link nuts to 50 N.m (37 lb ft).

  3. Install the front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  4. Lower the vehicle.
scientia non olet · About LEMON Manuals