LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 52 (Front Suspension System) >> Repair Instructions >> Lower Ball Joint Replacement >> Assembly Procedure

Assembly Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Ball Joint, Control Arm & Mounting Bolts
    GM1241982Courtesy of GENERAL MOTORS CORP.
  1. Connect the ball joint to the control arm with the mounting bolts.
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
  2. Install the nuts to secure the bolts from below the control arm.

    Tighten:  Tighten the ball joint-to-control arm nuts to 64 N.m (47 lb ft).

  3. Install the control arm. Refer to Control Arm Replacement .
  4. Install the front wheel. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
  5. Lower the vehicle.
scientia non olet · About LEMON Manuals