Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Tail Lamp Assembly and Screws (Notchback)

Courtesy of GENERAL MOTORS CORP.

Install the bulb(s).

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the lamp assembly with the screws.
Tighten: Tighten the tail lamp assembly nuts to 3 N.m (27 lb in).
Connect the electrical connectors.
Install the luggage compartment rear quarter trim panel.