Automatic Transaxle Gear Position Illumination Lamp Inoperative, All Other Instrument Lamps OK

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Step	Action	Values	Yes	No
NOTE: When probing a bulb socket with a voltmeter or a test lamp, do not allow the probe to touch both the positive and the negative contacts at the same time. This will cause a blown fuse.
1	Inspect fuse EF15. Is fuse EF15 open?	-	Go to Step 2	Go to Step 3
2	Check for a short circuit and repair it, if necessary. Replace the open fuse. Is the repair complete?	-	System OK	-
3	Turn the lamp switch ON. Use a voltmeter to check battery voltage available at fuse EF15. Does the battery voltage match the value specified?	11-14 V	Go to Step 5	Go to Step 4
4	Repair the open circuit power supply circuit to fuse EF15. Is the repair complete?	-	System OK	-
5	Turn the lamp switch ON. Remove the automatic transaxle position lamp. Use a voltmeter to check battery voltage available at the lamp socket. Does the battery voltage match the value specified?	11-14 V	Go to Step 7	Go to Step 6
6	Repair the open circuit between the automatic transaxle position lamp socket and fuse EF15. Is the repair complete?	-	System OK	-
7	Turn the lamp switch ON. Remove the automatic transaxle position lamp. Use an ohmmeter to check the resistance between the ground circuit and the lamp socket. Is the resistance equal to the value specified?	0 Ω	Go to Step 9	Go to Step 8
8	Repair the open ground circuit between the automatic transaxle position lamp socket and ground. Is the repair complete?	-	System OK	-
9	Replace the automatic transaxle position lamp. Is the repair complete?	-	System OK	-