LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 45 (Heating, Ventilation And Air Conditioning) >> Repair Instructions >> Heater Hoses Replacement >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Partially drain the cooling system.
  2. Compress and slide rearward the two heater hose spring clamps at the fire wall.
    Fig 1: Heater Hoses At Heater Core
    GM1251914Courtesy of GENERAL MOTORS CORP.
    3. Fig 2: Heater Hose Spring Clamp & Inlet Coolant Line
    GM1241693Courtesy of GENERAL MOTORS CORP.
  3. Gently twist the hose from the left to the right and back again to loosen the bond between the hose and the tube.
  4. Remove the end of the hose from the tube.
  5. Repeat Steps 3 and 4 with the other hose.
  6. Compress the heater hose spring clamp on the inlet coolant line and slide the clamp rearward.
  7. Remove the hose from the vehicle.
  8. Compress the heater hose spring clamp at the connection below the intake manifold and slide the clamp rearward.
  9. Remove hose from the vehicle.
scientia non olet · About LEMON Manuals