Installation Procedure
WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
Refer to Safety Glasses Caution
in Cautions and Notices.
- Coat the rack bearing, the adjuster spring, and the adjuster plug with lithium-based grease.
- With the rack centered, turn the adjuster plug clockwise until a torque of 12 N.m (9 Ib ft) is obtained, then back it off by 50-70 degrees.
Tighten: Tighten the adjuster plug to 12 N.m (9 Ib ft).
NOTE:
Refer to Fastener Notice
in Cautions and Notices.