LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 42 (Front Drive Axle) >> Repair Instructions >> Wheel Drive Shaft Inner Joint and Seal Replacement (Manual) >> Removal Procedure

Removal Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the large seal retaining clamp. Discard the clamp.
  2. Remove the small seal retaining clamp. Discard the clamp.
    Fig 1: Removal Of Small And Large Seal Retaining Clamp
    GM1242033Courtesy of GENERAL MOTORS CORP.
  3. Degrease the joint.
  4. Remove the shaft retaining ring using the J 8059  (1). See Special Tools and Equipment .
    Fig 2: View Of Shaft Retaining Ring With J 8059
    GM1242032Courtesy of GENERAL MOTORS CORP.
    5. Fig 3: View Of Axle Shaft And Joint Assembly
    GM1242031Courtesy of GENERAL MOTORS CORP.
  5. Remove the axle shaft from the joint assembly.
    6. CAUTION: The ball retainer is stacked in position and is not serviceable. Attempting to service the ball retainer could result in reduced vehicle performance and possible personal injury.
  6. Remove the seal from the joint assembly.
scientia non olet · About LEMON Manuals