LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 41 (Disc Brake System) >> Repair Instructions >> Brake Rotor Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
  1. Inspect the rotor. Refer to Brake Rotor Surface and Wear Inspection .
    2. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 1: View Of Rotor-to-Front Wheel Hub Detent Screw
    GM1245700Courtesy of GENERAL MOTORS CORP.
  2. Install the rotor to the front wheel hub by tightening the detent screw.

    Tighten:  Tighten the rotor-to-front wheel hub detent screw to 4 N.m (35 lb in).

  3. Install the caliper bracket.

    Tighten:  Tighten the caliper bracket mounting bolts to 95 N.m (70 lb ft).

  4. Install the caliper assembly. Refer to Brake Caliper Replacement .
scientia non olet · About LEMON Manuals