Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View Of Coolant Heater And Seal

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the seal to the coolant heater.
Install the coolant heater in to the engine block.
Tighten: Tighten the coolant heater to 60 N.m (44 lb ft).
Connect the coolant heater power supply cord to the coolant heater.
Fill the cooling system. Refer to Draining and Filling Cooling System .