Cooler Pipe Bending and Choke Inspection
WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
- Replace failure parts.
- Apply compressed air of 2 kg/cm 2 from cooler pipe inlet side (1), inspect whether there is not cooler pipe choke by confirming air flow smooth.
- Remove foreign particles and clean inside of pipe line.
IMPORTANT:
Inspect if there is abnormal pipe bending in the cooler pipe, pipe deformation and small cross-section area of pipe line.