LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2005 >> Aveo Base, 4D Hatchback >> Repair and Diagnosis >> External Pages >> Different car >> Section 30 (HVAC Systems - Manual) >> Repair Instructions >> HVAC Control Assembly Replacement >> Installation Procedure

Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: Mechanical Control Cables & Electrical Connectors
    GM1251904Courtesy of GENERAL MOTORS CORP.
  1. Connect the electrical connectors to the proper sockets on the back of the controller.
  2. Install the mechanical cable housings to the proper control positions.
  3. Install the eyelets on the end of each cable, pressing each onto the proper post.
  4. Install the controller by gently inserting the controller into the proper position on the center console.
    5. NOTE: Refer to Fastener Notice in Cautions and Notices.
    Fig 2: Locating HVAC Controller Retaining Screws
    GM1251902Courtesy of GENERAL MOTORS CORP.
  5. Install the lower left and the lower right controller retaining screws.

    Tighten:  Tighten the HVAC controller retaining screws to 3 N.m (27 lb in).

  6. Install the instrument panel lower cover. Refer to Instrument Panel (I/P) Trim Panel Replacement - Lower in Instrument Panel, Gages and Console.
  7. Connect the negative battery cable.
  8. Confirm the proper operation of the controller by moving it through all of the controller's possible functioning positions.
scientia non olet · About LEMON Manuals