Installation Procedure

WARNING: This page is about a different car, the 2004 Suzuki Swift + and 2004 Chevrolet Aveo. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: View of Electrical Connections and Wiper Switch

Courtesy of GENERAL MOTORS CORP.

Connect the electrical connections to the wiper switch.

Fig 2: View of Wiper Switch and Switch Housing

Courtesy of GENERAL MOTORS CORP.

Install the wiper switch by snapping it into the switch housing.

Fig 3: View of Upper Steering Column Cover Panel and Screws

Courtesy of GENERAL MOTORS CORP.

NOTE: Refer to Fastener Notice in Cautions and Notices.

Install the lower steering column cover panel. Install the lower steering column cover panel screws.
Tighten: Tighten the lower steering column cover panel screws to 3 N.m (27 lb ft).
Install the upper steering cover panel. Install the upper steering column cover panel screws.
Tighten: Tighten the upper steering column cover panel screws to 3 N.m (27 lb ft).
Connect the negative battery cable.